Your browser is out of date.

You are currently using Internet Explorer 7/8/9, which is not supported by our site. For the best experience, please use one of the latest browsers.

Request a Quote

Blocked Chute Protection For Wet Applications

Technology For Blocked Chute Detection

HAWK has designed and developed the most reliable and accurate products for blocked chute prevention and protection. HAWK has created the world’s first microwave switch that can be used to predict blockage and build-up before it even occurs. This type of revolutionary technology eliminates downtime and increasing productivity and profitability.

Microwave Switches are traditionally used as Blocked Chute switches. All the Microwave switches available in the market tells you that the chute is blocked. Some switches can give a false alarm and trip because of build up on the chute walls. This causes lot of downtime to the mine site costing them valuable time and money.

Most of the mines are now looking for ways to reduce the production cost to increase their profitability. Mines are now looking at improving the reliability from field instrumentation. They want more information out of the instruments so they can optimize the process. One of the ways to increase optimization is Preventive Maintenance.

Historically mines have installed HAWK’s Gladiator Gen 3 Microwaves and reduced their downtime from false trip as these switches are able to punch through considerable amount of build up before they trip. Even with the genuine trip, the site has to carry out time consuming tasks of clearing the blockage, cleaning the chute and starting the belts again. This can take more than 2hrs depending on the blockage and the material.

As industry leader, HAWK has been approached on various occasions by the mines to give them more information, for instance, measuring buildup in the chute. While it’s difficult to measure the actual build up size using microwave HAWK has introduced a Smart Amplifier that uses special algorithm and Signal Strength that can be considered directly proportional to the buildup.

Mines can now TREND the Signal Strength in their PLCs to allow for preventive maintenance. If the Signal is continuously going down it is an indication that the Microwave Sender and Receiver are struggling to communicate with each other which is a sign of build up inside the chute wall.

Logic block can be set in the PLC to send an alarm when the Signal has dropped too low and the operations team can go check it and take steps before the chute blocks or the Microwaves trip because of buildup.

The HAWK Gladiator Microwave is designed to accommodate for these conditions. The world-leading receiving circuitry detects and amplifies the diminished signal. Using HAWK’s Signal reading this is a measurable condition. HAWK is able to use a relay to notify operators the chute requires maintenance before an emergency occurs, while using high speed communications to transmit the Signal data live.

Recommended Products for Blocked Chute

Gladiator G3 Microwave Switch

The Gladiator Gen 3 Microwave Switch can be used for blockage detection, barrier detection, machine detection, collision detection for protection, point level measurement, and detection of objects or material between two points.

Gladiator G1 Microwave Switch

The Gladiator Gen 1 Microwave Switch can be used for blockage detection, barrier detection, machine detection and point level measurement, and detection of objects or material between two points.

Contact Us

We will respond to all messages within 24 hours

USA: +1 (888) 429-5538 AU: +61 (0)3 9873 4750